For connecting a Plus II or MultiMAX with no ACC port to a Nikon MC-DC1 remote terminal, through a Pre-Trigger switch
Cable length: 3' (91.5 cm)
From 1/8" (3.5 mm) Mono Miniphone
Via Pre-Trigger Switch
To Nikon MC-DC1 remote shutter release terminal
· Plus II
· MultiMAX with no ACC port
· Use the NM4-ACC for the PlusX, Plus III, MultiMAX with ACC port, or FlexTT5 radios
Description: This cable contains a pre-trigger switch. When enabled, the camera behaves as if the camera's shutter release button were held half-pressed continuously. This makes the camera respond more quickly and consistently, but also consumes the camera's batteries much more quickly. When disabled, this cable functions identically to the NM4.
This –P cable works with most PocketWizard radios. This pre-trigger cable has a switch that allows you to toggle half-press on or off at the camera position, but not remotely.
A standard cable works with most PocketWizard radios but has no half-press control, and is for basic remote triggering only.
A –ACC cable allows a compatible PocketWizard radio to independently control both half-press and full-press functions, as well as relay E-TTL signals to compatible flashes when using FlexTT5s.
Compatible with the following radios:
Plus II: Use this cable to remotely fire your camera.
Plus III : This cable can remotely fire your camera and control half-press function at the camera’s position. Use a –ACC cable for best results and to have half-press capability from the transmitting radio.
MultiMAX with no –ACC port: Use this cable to remotely fire your camera and control half-press function at the camera’s position.
MultiMAX with –ACC port: This cable can remotely fire your camera but cannot wake up the camera in a remote zone. Use a –ACC cable for best results
FlexTT5: This cable can remotely fire your camera and control half-press function at the camera’s position, but your remote camera will not be able to relay an E-TTL signal to Speedlites. Use a –ACC cable for best results. Learn more here
Compatible with cameras using Nikon MC-DC1 remote terminal including:
D70S (not D70)
For cameras with MC-DC2 remote terminal, use N-MCDC2-P.
For remotely triggering a flash equipped with a 1/8" (3.5 mm) mono miniphone sync...
The PocketWizard AC7 RF Shield for FlexTT5 solves the problem of limited performance of the...
Locking PC Sync Cable For connecting to a locking/non-locking PC terminal. Cable length: 5' (1.5...
Subscribe to our newsletter and always be the first to hear about what is happening.
|Melbourne||(03) 9672 2222|
|Sydney||(02) 8004 7945|
|Brisbane||(07) 3103 1429|
|Perth||(08) 6102 6382|
|Adelaide||(08) 7200 3773|
|Darwin||(08) 8911 1262|
|Canberra||(02) 6176 0125|
|Hobart||(03) 6107 9442|
|Auckland||(09) 887 0479|
© 2017 michaels camera video digital.